Around Wednesday, my friend asked if we could play D&D on Saturday. It had been a while, so I said sure. Later, I realized I had a lot of work to do, and the weather was going to be nice, so last night I tried to cancel. I realized that was kinda short notice, and it's tough to schedule, so I agreed to a half-session. It turned out to take almost as long as a regular game, so I didn't have much time in the afternoon to work. I did a little bit of gardening, and a little bit of work in the shed.
After supper I painted. It turns out that the paint went much further than the primer did, so I had enough to do two coats on everything. So paint is done. I just have to wait a few days for it to dry and harden before I hang the stuff back on the wall.
I washed the grimy switchplates. I should find screws that aren't rusty, to put them back up. I swept the floor of Cindy's side, so her car can go back in tomorrow.
I installed the garage door opener a year ago February. The safety sensors were still sitting on the floor at the side of the garage, in their temporary place. So I was messing with them a little bit. I unplugged the garage door opener to reroute the cord, and the thing reset. I had to dig out the installation manual. I don't usually save them because why would you need an installation manual after you've installed it? Apparently there are operating instructions as well as installation instructions? Next time I can just search for "garage door opener reset after power outage." You have to go through this process to reset it every time power is interrupted. Otherwise it will not close.
After supper I painted. It turns out that the paint went much further than the primer did, so I had enough to do two coats on everything. So paint is done. I just have to wait a few days for it to dry and harden before I hang the stuff back on the wall.
I washed the grimy switchplates. I should find screws that aren't rusty, to put them back up. I swept the floor of Cindy's side, so her car can go back in tomorrow.
I installed the garage door opener a year ago February. The safety sensors were still sitting on the floor at the side of the garage, in their temporary place. So I was messing with them a little bit. I unplugged the garage door opener to reroute the cord, and the thing reset. I had to dig out the installation manual. I don't usually save them because why would you need an installation manual after you've installed it? Apparently there are operating instructions as well as installation instructions? Next time I can just search for "garage door opener reset after power outage." You have to go through this process to reset it every time power is interrupted. Otherwise it will not close.